1

I want to mount an Arduino Pro Micro inside my PC, hooked up to the PC's USB.

I don't want to have external cables for this, but have it neatly cabled inside.

My motherboard has USB connectors with 9 pins (5+5 grid, 10th pin key), like these: motherboard

These connectors would take a cable that looks like this:

9pin cable

But how would I connect this to the Arduino that has Micro USB?

I've been looking everywhere, but 9-pin USB to USB Micro does not seem to exist?

The closest I could find is a cable that goes from USB micro to a 5-pin header:

5pin cable

What is the preferred way to hook up an Arduino Micro with internal cabling?

Why does the 9-pin to USB-micro not exist?

3
  • why 9 pin USB to USB? .... top picture shows two USB cables
    – jsotola
    Sep 23 at 0:50
  • @jsotola I don't understand what you mean. Top picture is of a motherboard with 2 USB connectors. Middle pic is of a connector that would fit it. Bottom pic is of a cable that I found to be available. What is missing is a cabled that is 9-pin one end, and micro usb at the other end.
    – Bram
    Sep 23 at 1:06
  • 2
    sorry, 2nd picture shows two separate usb cables
    – jsotola
    Sep 23 at 1:34
4

@Bram, @jsotola is highlighting in the comments that the example photo you show with a 9 pin keyed two row connector has two usb cables connecting to it. USB connections often have four wires each. The standard wire color coding is:

usb wiring Colours (Source Wikipedia - USB)

Board manufacturers are often looking for a simple way to connect multiple panel mount USB ports to the PCB and this could have been a cheap and convenient way to connect two USB ports per pcb connector.

Some suggestions:

  • Research the specific motherboard online to see if a schematic or connector layout is available. It’s quite likely to be laid out like this:

enter image description here

  • Experiment by making your own connector, and use a multimeter to figure out which are the power and which are the data wires.
  • If the old USB ports which used to connect to the PCB are still available, investigate further until you’re more confident about how they were wired.
  • An adapter may help you experiment further to understand the PCB connections further.

enter image description here

4
  • 1
    no need to experiment. 5th pin in micro is for otg ID: electronics.stackexchange.com/questions/35462/…
    – Abel
    Sep 23 at 12:34
  • Thank you! My local electronics shop had the breakout board in stock! I don't know yet what to do with pin ID, though. I think it is needed to specify which side is device, and which side is host.
    – Bram
    Sep 23 at 16:58
  • I think the PC as host would be a could configuration to try first.
    – RowanP
    Sep 23 at 22:02
  • @Bram, checkout @Abel’s link in the comment above for more information about the ID pin.
    – RowanP
    Sep 23 at 22:06

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.