0

I bought ethernet Shield today and connected it to Arduino Uno, now when I try to upldoad I get the following error, however if I remove the shield from the UNO it works fine.

Sketch uses 10,486 bytes (32%) of program storage space. Maximum is 32,256 bytes.
Global variables use 661 bytes (32%) of dynamic memory, leaving 1,387 bytes for local variables. Maximum is 2,048 bytes.
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 3 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 4 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 5 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 6 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 7 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 8 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 9 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 10 of 10: not in sync: resp=0x00

Ethernet is not plugged in

Is it something wrong with he ethernet shield ? Ethernet is not plugged in but even when i plug in the ethernet wire the indicators at Jack does not lit up

Improve this question
8
  • Unplug your ethernet shield. Then upload your program. Plug in your ethernet shield and check if your program is working fine. If your program is not working as expected, there may be some issues with the shield.
    – Aircraft
    Commented Nov 3, 2016 at 12:57
  • I have tried that already it didn't helped
    – Ciasto piekarz
    Commented Nov 3, 2016 at 13:00
  • What was not working. Your program was not working or you were getting errors uploading code.?
    – Aircraft
    Commented Nov 3, 2016 at 13:02
  • Error uploading code when shield is plugged in
    – Ciasto piekarz
    Commented Nov 3, 2016 at 13:02
  • Upload the code and then plug in your shield. Then check if your uploaded code is working correct or not.?
    – Aircraft
    Commented Nov 3, 2016 at 13:04

1 Answer 1

Reset to default
0

I fixed the problem by cleaning the soldering near the SD card slot on ISCP, see image below.

enter image description here

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.