Arduino IDE upload error

Question

I've recently been trying to make program using IRremote(library) in my Arduino IDE(v1.8.9), but whenever I hit the upload button this error message is returned

Sketch uses 7514 bytes (23%) of program storage space. Maximum is 32256 bytes. Global variables use 415 bytes (20%) of dynamic memory, leaving 1633 bytes for local variables. Maximum is 2048 bytes.

avrdude: verification error, first mismatch at byte 0x0002

0x5d != 0x62 avrdude: verification error; content mismatch

avrdude: verification error; content mismatch

I'm using Arduino UNO R3

This is the code I'm trying to run

    #include <IRremote.h>
int RECV_PIN = 11;
IRrecv irrecv(RECV_PIN);
decode_results results;

void setup()
{
  Serial.begin(9600);
  irrecv.enableIRIn(); // Start the receiver
}

void loop()
{
  if (irrecv.decode(&results))
    {
     Serial.println(results.value, HEX);
     irrecv.resume(); // Receive the next value
    }
}

Also, every other code(not using the IRremote library) uploads just fine without any errors.

Answer 1

There can be power/connection problem or somehow the bootloader has been damaged. So

• Check power
• Check Connection
  

If there no problem found, then by using usbasp, avrisp, usbtinyisp, etc reflash the bootloader. I hope your problem will be solved.