1

I have been experimenting with pwm dimming using TIP120 on various high powered LED's, and have noticed a marked drop in the top level brightness compared to original connection without the tip 120 in line. For instance a 70w panel connected with heavier gauge cable (not using jumper cables) no longer reaches full brightness with pwm set too full. im using tasmota on a nodemc8266. Is there something inherent the hardware set up causing the loss that I am missing or is there a software limitation with PWM? curious

thanks

Improve this question
4
  • don't know if it is the cause, but PWM in arduino esp8266 core is software PWM: pin is toggled in timer interrupt
    – Juraj ♦
    Commented Jul 5, 2019 at 10:44
  • 1
    Remove the PWM and just set the pin to HIGH. Then see if there is still a difference. My guess is that there is. I think the TIP120 will have a relatively high voltage drop across it. Making the leds less bright. If that's the case I'd switch to a MOSFET instead of a bipolar (darlington) transistor
    – Gerben
    Commented Jul 5, 2019 at 13:27
  • 1
    One of the main disadvantage of a Darlington transistor pair is the minimum voltage drop between the base and emitter when fully saturated. Unlike a single transistor which has a saturated voltage drop of between 0.3v and 0.7v when fully-ON, a Darlington device has twice the base-emitter voltage drop (1.2 V instead of 0.6 V) as the base-emitter voltage drop is the sum of the base-emitter diode drops of the two individual transistors which can be between 0.6v to 1.5v depending on the current through the transistor.
    – VE7JRO
    Commented Jul 5, 2019 at 17:50
  • thank you, all of these comments make such sense and i will experiment with each so I methodically understand the process, and then finally follow up with the specific mosfets as described by @crossroads.
    – OTTO
    Commented Jul 6, 2019 at 20:54

1 Answer 1

Reset to default
0

Replace the TIP120 with a Low Rds N-channel MOSFET. Look at AOD508 or AOD514 for example, very low Rds, so it will develop very little voltage drop as the current increases.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.