1

I'm using the arduino uno hooked up to two LEDs. One is in pin 3 and the other one in pin 5. I know that pin 3 is controlled by timer3 and pin 5 by timer 1. I've tried a lot of things to have two independent frequencies. I really don't care about the PWM, I have it to 50% (constant).

There are resources to set the frequency (http://playground.arduino.cc/Main/TimerPWMCheatsheet), but these are predefined frequencies. I need to have one PWM at 650Hz and the other at 850Hz.

Any recommendations on how to approach this problem?

migrated from stackoverflow.com Sep 25 '14 at 18:14

This question came from our site for professional and enthusiast programmers.

3

The ATMega PWM hardware underlying the Arduino primarily supports changing the duty cycle; the frequencies can only be selected from a few fixed choices. Typically the timers run from 0 to 255 or 65535 and loop back to 0, and you can select where within that full cycle the output changes on and off.

Since what you want is a simple 50% duty cycle with fine control of frequency, the PWM functions are not very useful. What you want is tone or frequency control. The ATMega timers support this too, but it's a different function than PWM. For frequency control, the timer will cycle from 0 to your choice of upper limit. So for example, you might count up to 200 instead of 255; or to 201 - so you get much finer control of frequency.

Unlike PWM, on the ATMega328p used in the Uno, you can only get one frequency per timer (you can get two PWM outputs per timer - both at the same frequency). And if you want millis() and microseconds() and delay() to continue to work, you don't want to mess with timer 0 for frequency control (you can get PWM from timer 0 if you accept the default frequencies).

So that leaves you with two frequency controllable timers - timer 1 (16 bit resolution) and timer 2 (8 bit resolution).

See the tone() function in the Arduino library for examples of a single tone at a time.

For multiple simultaneous frequencies (on different pins) see this library: https://code.google.com/p/rogue-code/wiki/ToneLibraryDocumentation. You can have two tones at a time, or three if you don't need millis() etc.

0

There is a great library with functions to change PWM frequency on Arduino microcontrollers, called arduino-pwm-frequency-library. I hope this helps you.

0

IF you need to dim leds use:

/*PWM signal on most pins is approximately 490 Hz
On the Uno and similar boards, pins 5 and 6 
have a frequency of approximately 980 Hz
brightness1, brightness2 = from 0(0v) to 255(5v)
So make eqution to calculate needed frequency*/

//LED are connected to:
const int ledPin1 = 5; 
const int ledPin2 = 6; 
byte brightness1 = 100; // ~2v
byte brightness2 = 200; // ~4v
void setup()
{
  // initialize the ledPin as an output:
  pinMode(ledPin1, OUTPUT);
  pinMode(ledPin2, OUTPUT);
}

void loop() {
    // set the brightness of the LED:
    analogWrite(ledPin1, brightness1);
    analogWrite(ledPin2, brightness2);

}

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.