All Questions
Tagged with pressure arduino-uno
9 questions
2
votes
1
answer
953
views
Connecting pressure sensor to Arduino to collect pressure and time data
I'm trying to build a pressure data logger using an Arduino and Mindman MP47P-03-F1 (https://www.mindman.com.tw/proimages/pdf/E_MP47_S.pdf) pressure sensor, the sensor is connected to an outer 12-24 ...
- 29
-1
votes
2
answers
360
views
Pressure Switch 4-20mA
Im working on a project trying to read the pressure value from an Allen Bradley Pressure Transmitter 836P-D2NFGB20PA-D4 Ser.A
However the pin configuration that comes on the description along with ...
0
votes
2
answers
535
views
Arduino Force sensitive Resistor with an lcd
So we were asked to do something with a force sensitive resistor so naturally i thought of a project which takes the name of the main component which is force and applies it ,mine works by as you ...
2
votes
0
answers
3k
views
5V Pressure sensor module with 3.3V ADC
I'm using ESP32 to read analogue pressure readings from this pressure transducer. My Problem is this sensor outputs 0.5V – 4.5V linear voltage output based on the pressure but ESP32 can only handle 0 -...
- 143
0
votes
1
answer
749
views
4-20 milliamp to volts to pressure maths
I am measuring pressure in bars from OsiSense™ XMLP pressure sensor (4-20 milliamp) on a arduino uno. When the machine im measuring pressure on is switched off the reading is 0v as expected.
When the ...
- 155
1
vote
1
answer
18k
views
Reading 4 to 20ma pressure sensor using uno
I have a OsiSense™ XMLP pressure sensor that I want to read from my Arduino uno. This is the circuit I am looking at building for measure 4 to 20 milliamp.
I've read online to find out how to build ...
- 155
1
vote
3
answers
299
views
Using Multiple identical sensors - Beginner [closed]
I'm trying to make an interactive installation where I have 6 pressure pads that each control an Air Fan. The pressure sensors ideally will be on chairs.
I would like the changes in pressure to ...
- 21
1
vote
0
answers
1k
views
Pressure Sensor-MPX10DP with amplifier and Arduino UNO - output to kPa
I'm working with an Arduino UNO. I'm trying to use this Sensor to obtain the pressure in kPa. I'm using a tl084cn to amplifier the signal. But I don't know what values I'm getting and what to do with ...
- 123
0
votes
2
answers
844
views
Press on pressure sensor once, turn on LED for 6 seconds
I am working on a project where I would like to press on a pressure sensor (0-1024) once and turn on the LED and turn off by itself after 6 seconds. I am quite new to arduino and I can't seem to ...
- 1