0

i'm trying to understand how to connect this motor:

"Mitsumi 334P/R AB"

Link to the motor i bought

enter image description here

connections are:

GND - Obvious.

5v - Obvious.

rest of the connections are a bit confusing to me and i do not want to fry my arduino trying.

  • do i need a driver or this looks like a built in one?
  • do i need to add any electrical components like resistors and capacitors ect?
Improve this question

1 Answer 1

Reset to default
1

It's just a regular motor, with a (optical) rotary encoder inside. So the first two motor pins are to run the motor. So connect to VCC and GND, or GND and VCC, if you want to run it in reverse. (VCC doesn't have to be 5v; it can be 3v to 30v).

Connect A and B to a digital input pin. You can see what kind of signal you can expect in the screenshot of the oscilloscope, attached to the ebay-listing. So you can measure the speed, and relative position of the motor-shaft.

Improve this answer
2
  • is there a way to decide (like stepper motor) to rotate 200 right/left? or this is a different kind that only measures speed and rotations?
    – Mike
    Commented Apr 7, 2015 at 13:47
  • 1
    You can turn on the motor, measure how many steps it's making, and turn off the motor when you reach 200 "steps". This is however grossly oversimplified, as in reality, due to inertia, you will probably overshoot these 200 steps. You probably need to slow down the motor (using PWM), when it's closing in on 200. Some kind of PID control.
    – Gerben
    Commented Apr 7, 2015 at 16:03

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.