1

I got an error "stk500_getsync() not in sync resp=0x00" when I tried to update an Arduino Pro Mini with an FTDI Basic Breakout 5V/3.3V - Micro USB. Maybe someone has instructions on how to resolve this issue. I use the last version of Arduino IDE. All standard stuff like drivers, ports installed and configured.

I have communication with controller and I receive answers from it, but when I try to flash the firmware I get that error.

Improve this question
0

1 Answer 1

Reset to default
0

It's your COM port or your board selection.

I often use the Pro Mini and an Uno and when I forget to change either the COM port or the board to which I have to upload the sketch to, that error message happens.

Improve this answer
2
  • I updated question.
    – Atlantis
    Commented Oct 17, 2016 at 9:49
  • Maybe wrong driver. There is only one FTDI driver.
    – Dat Ha
    Commented Oct 17, 2016 at 11:36

Not the answer you're looking for? Browse other questions tagged or ask your own question.