the Answer to this question is this connect a push button swith to ground and rst pin

click upload then push the button twice (fast) (doesnt matter if your computer does not recognize the pro micro)

repeat this if it failed (repeat until you will conquer victory!)

after this the pro micro port will comeback to life! hahaha

I tested it. the reason I think is that you upload in a wrong board Commonly the 3.3v and 5v (vice versa)

Try this:

1. Connect a push button switch to ground and reset (RST) pin;

2. Click upload then push the button twice (fast) = it doesn't matter if your computer does not recognize the pro micro;

3. Repeat this if it failed (repeat until you are successful).

After this the Pro Micro port will comeback to life.

I tested it. The reason I think that you bricked it, is because you uploaded using the wrong board setting - commonly the 3.3 V and 5 V (or vice versa)