I'm taking my first wobbly steps outside the Arduino IDE and I'm not having much success with timers / interrupts. I can set a pin to output and light an LED with registers fine but I cannot for the life of me get timers to work. I have tried numerous tutorials and followed the Atmel ATmega328 datasheet very closely.

Using an Arduino Uno R3 & Atmel ICE (ISP.) My dev system is Raspbian (Debian) with the GNU AVR toolchain (avr-gcc, avr-objcopy, avrdude.) Apart from not having a bootloader it's a bog standard board (including fuses.)

Here's my current code:

#include <avr/io.h>
#include <avr/interrupt.h>

ISR(TIMER0_COMPA_vect)
{
    PORTB ^= (1 << PB5); // Toggle Arduino Pin #13
}

int main (void)
{
    DDRB = (1 << DDB5); // Arduino Pin #13 is Output

    cli(); // Clear Interrupts

    OCR0A = (unsigned char)0xFF; // Compare Register A = 255
    TIMSK0 = (1 << OCIE0A); // Enable Interrupt for Comp. Reg. A
    TCCR0A = (1 << WGM01); // CTC Mode

    sei(); // Set Interrupts
    TCCR0B = (1 << CS02) | (1 << CS00); // Divide by 1024 Prescaler (GO!)

    return 0;
}

I don't know if I'm just not seeing something or if I've set registers in the wrong order but it's driving me crazy.

I'm taking my first wobbly steps outside the Arduino IDE and I'm not having much success with timers / interrupts. I can set a pin to output and light an LED with registers fine but I cannot for the life of me get it to blink using a timer. I have tried numerous tutorials and followed the Atmel ATmega328 datasheet very closely.

Using an Arduino Uno R3 & Atmel ICE (ISP.) My dev system is Raspbian (Debian) with the GNU AVR toolchain (avr-gcc, avr-objcopy, avrdude.) Apart from not having a bootloader it's a bog standard board (including fuses.)

Here's my current code:

#include <avr/io.h>
#include <avr/interrupt.h>

ISR(TIMER0_COMPA_vect)
{
    PORTB ^= (1 << PB5); // Toggle Arduino Pin #13
}

int main (void)
{
    DDRB = (1 << DDB5); // Arduino Pin #13 is Output

    cli(); // Clear Interrupts

    OCR0A = (unsigned char)0xFF; // Compare Register A = 255
    TIMSK0 = (1 << OCIE0A); // Enable Interrupt for Comp. Reg. A
    TCCR0A = (1 << WGM01); // CTC Mode

    sei(); // Set Interrupts
    TCCR0B = (1 << CS02) | (1 << CS00); // Divide by 1024 Prescaler (GO!)

    return 0;
}

I don't know if I'm just not seeing something or if I've set registers in the wrong order but it's driving me crazy.