Skip to main content
Boggyman's user avatar
Boggyman's user avatar
Boggyman's user avatar
Boggyman
  • Member for 3 years, 8 months
  • Last seen more than 2 years ago
6 votes

Is it possible to generate an exact 15 kHz clock pulse using an Arduino?

3 votes

Is there any better choice other than using delay() for a 6-hours delay?

3 votes

How the light brightness stays constant when we increase the frequency of stroboscope

2 votes

Arduino "Maximum Power point tracker" (MPPT) Problem

2 votes

Sketch skipping the OPEN Arduino inputs

2 votes
Accepted

Stable amplitude of amplified signal

2 votes
Accepted

Controlling op amps amplification ratio by arduino

2 votes
Accepted

How to improve the sampling rate of Arduino due ADC?

2 votes

Atmega328 and ADXL335 - is the right choice for vibration analysis?

2 votes

Can I test if something is connected to analog pin?

1 vote

Firmata: strings sent from the computer become damaged after Arduino

1 vote

How to separate a specific frequency signal from a summation of a few signals?

1 vote

Differential voltage measurement using Arduino

1 vote
Accepted

Using PWM pins on the UNO to generate Stereo Sound

1 vote
Accepted

How should I decide the cut-off frequency for my low-pass filter?

1 vote

How can i increase the range of values that a light sensor gives?

1 vote
Accepted

Multiple external power sources and one Arduino

1 vote

What is the maximum frequency input signal that I can accurately track on a GPIO pin?

1 vote
Accepted

Arduino send commands fast

1 vote

Convert fuel level sender resistance ranges - good Arduino project?

1 vote

Sense person connected to TENS unit

1 vote

Collecting data from a timer interrupt and storing it into an array

0 votes

Timer Interrupt Collision

0 votes

Can we generate 20kHz tone with normal buzzer in arduino?

0 votes

DC motor fan speed control with Temperature Sensor

0 votes
Accepted

Multitasking with Arduino?

0 votes

Am I at the limit of UART transmission time?

0 votes

Digital pin output voltage drops when driving a relay

0 votes

How to use millis() in my code instead of delay()?

0 votes

Plotting data from Arduino and using the serial monitor in parallel