Skip to main content
jsotola's user avatar
jsotola's user avatar
jsotola's user avatar
jsotola
  • Member for 6 years, 7 months
  • Last seen this week
6 votes

How to upload code without closing puTTY

6 votes

How do you handle sensor drift?

6 votes

Smoke coming out of Arduino Uno R4 Minima

4 votes

Tone() generates a high pitched sound when button is released

4 votes
Accepted

Can I use 1-byte datatypes to store digital input?

3 votes

Emit region-neutral keyboard signals

3 votes
Accepted

How to deal with unusual neopixel grid

3 votes

Arduino IDE c++ 11 raw string literal have issues with // in http://, complier thinks // is comment

3 votes
Accepted

Cannot compile code from Arduino WIFI shield example

3 votes
Accepted

Functions delaying gesture sensor recognition

3 votes

How to remove Arduino Due and Mega shields without bending pins?

3 votes
Accepted

How can I break the loop if it hasn't finished in 10 seconds?

2 votes

fastLED help - special reinforcements needed

2 votes

I want a Rotary Encoder to make 10 steps at once, but my code isn't working. What am I doing wrong?

2 votes

Importing content of text file as string into Arduino code

2 votes

Fixing a pedestrian traffic light sequence pattern in a cycle using millis and without delay

2 votes

ARDUINO DC Motor Control over IR Sensor INPUT

2 votes
Accepted

How to drive two Stepper motors and use an Ultrasonic sensor together?

2 votes

Rescuing an Arduino With a Broken Setup()

2 votes

How to boil down analog input to just three cases?

2 votes
Accepted

Can I remove soldered atmega328P from arduino board, using hot air gun, without damaging it?

2 votes

What Ohm Termination Resistor is needed for this schema ? What, Where and How?

2 votes

ENC28J60 is not getting ping

2 votes

240*320 transparent OLED display with Arduino

2 votes
Accepted

Servo doesn't move if I detach it AFER the write?

1 vote

What are patterns of bits sent to or read from GPIO pins called?

1 vote

How do i make my DC motors run simultaneously?

1 vote

Problem on interfacing 3 flame sensors and servo to Arduino Fire Fighter

1 vote
Accepted

What is the name of a peripheral which reads servo output data physically?

1 vote
Accepted

NEMA17 and DRV8825 200 steps give only half revolution