YaddyVirus
  • Member for 5 years, 9 months
  • Last seen more than a month ago
  • New Delhi, Delhi, India
Controlling Servo Motors with push button. Problem though
1 votes

Looks like your delay is too short. If the delay gets over before the servo can reach the set postion, it will skip that command and execute the next one. Also I agree with @julio about how are you ...

View answer
Unable to use Keyboard library with Arduino UNO even after changing the firmware
Accepted answer
0 votes

Okay, so the problem was that the added HID library was conflicting with the core Keyboard/Mouse library. I replaced the core library with the new one and it worked without any problems. Well one ...

View answer
Sketch behaves differently when motor driver is added
Accepted answer
0 votes

Okay I figured it out. Putting what I did here, for people who are curious and for those who need help. It was probably the Arduino, autoresetoverserialcomm, for some reason the Arduino auto-resets ...

View answer
Does serial communication between PC and Arduino has to be in a loop?
Accepted answer
0 votes

Just put a 10 µF capacitor between the 5v and RESET pins of your Arduino and do whatever you want, just make sure that the capacitor is connected after the board has been powered up, and also, remove ...

View answer
Sketch not running as expected
Accepted answer
0 votes

It was too damn simple... I just had to add a line inside the else block in the loop function. digitalWrite(brake1, LOW); This was happening because the first time the threshold limit was crossed ...

View answer
Arduino IDE get stuck while uploading sketch
Accepted answer
0 votes

Found the solution... Just connect the 5v from arduino to the 5v on the Module. Then another battery (12-36 V, I tried a 9v one... it worked but only for about 40 seconds), to the 12 V input, keeping ...

View answer