LegitimateWorkUser
  • Member for 5 years, 9 months
  • Last seen more than 3 years ago
1 answers
2 votes
559 views
How to purge incoming Xbee packets from the buffer?
3 answers
2 votes
634 views
Is it possible to configure FRAM memory for use as stack and heap?
2 answers
1 votes
547 views
Suddenly I can't compile any sketch. Not even a blink sketch that I compiled earlier
2 answers
1 votes
1k views
Solid-state relay boards: Can they be used to switch audio signals?
2 answers
1 votes
333 views
Xbee AT Commands failing. Something wrong with Serial? Tx commands working fine
1 answers
1 votes
237 views
System voltages: Can I use a 5V touchscreen shield on a 3.3V arduino?
1 answers
1 votes
2k views
I2C FRAM read/write is very slow. Taking over 500 microseconds per read, almost 500 per write
1 answers
1 votes
148 views
Can anyone help me figure out why this buffer is overflowing? (Updated)
1 answers
1 votes
303 views
1 bookmarks
Can I connect my arduino ground to an external battery ground? Are they the same when said battery is powering the arduino?
2 answers
0 votes
3k views
What's with the debug error messages, like VMDPE_1|1_VMDPE?
1 answers
0 votes
11k views
Using Sprintf() to left pad a string?
1 answers
0 votes
135 views
Are pins 0 and 1 (Rx and Tx) parallel with the USB jack? Can I connect another USB jack th 0 and 1 and use it to upload sketches?
1 answers
0 votes
177 views
Odd Serial behavior with Uno
1 answers
0 votes
155 views
I seem to be having trouble with these libraries and the Arduino 101. Can anyone look at my output and tell me what I should do?
2 answers
0 votes
2k views
"return" not working to break out of a loop
1 answers
0 votes
419 views
Can anyone help me spot where my buffer overflow might be occuring?