Skip to main content
OverflowAI is here! AI power for your Stack Overflow for Teams knowledge community. Learn more
Gil's user avatar
Gil's user avatar
Gil's user avatar
Gil
  • Member for 8 years, 7 months
  • Last seen more than a month ago
6 votes
Accepted

How can I check if my thermostat is on?

4 votes

Reasons why it is not OK to connect a relay directly from an Arduino digital pin

4 votes
Accepted

Inaccurate and non-precise voltage reading from Arduino Analog pin

3 votes

Set up a motion sensor to turn on lights and record how long the lights are on

3 votes

Sensor that detects when metal sieve is clogged with debris

3 votes
Accepted

Is it possible my ATMega is burnt due to bad wiring?

3 votes
Accepted

ESP32 Wifi not working when powered by battery

2 votes

Can I improve EEPROM lifetime by not changing bits?

2 votes
Accepted

Multiplexer 74HC4067, conflict between channels

2 votes

Arduino resets or stuck during run, only when DC motors are connected

2 votes

Break a big file into smaller files

2 votes

Sending minimal data between two Arduinos far away from each other

2 votes

How can I pause serial transfer and then un-pause it?

2 votes
Accepted

Arduino Multiplexer Input voltage per pin not decoupled

2 votes

Level shifter with diode - not pulling to zero

2 votes

Why are transistors necessary before LEDs?

2 votes

How do I connect 20 outputs and 20 inputs to an Arduino board?

2 votes

Switched from 3ft to 10ft connection wires. My setup doesnt run correctly now. Timing issues?

2 votes

Can't Upload Sketches to Arduino Nano Every

2 votes

CAN Bus without Transceivers

2 votes

How to interconnect multiple Arduinos with a Rpi to control home-lights/switches

2 votes
Accepted

ACS712 inacurrate reading. Wild jumping

1 vote

Why can't I use an optocoupler to drive an AC circuit using the arduino digital pins?

1 vote

How to capture good sound with Arduino?

1 vote

Write to EEPROM during power down

1 vote

Transient and reverse current

1 vote
Accepted

SoftwareSerial returns garbage when powered externally

1 vote

NRF24L01+ how much supply ripple is acceptable?

1 vote

Is it possible to create an interface between Teensy 3.2 and a DSP?

1 vote

two 7HC595 and only 12 outputs

1
2 3 4 5
8