1 of 5

The truth is always in the datasheets, the schematics and the code:

The Arduino UNO actually uses the /DTR line to trigger a reset, as you can see on the following datasheet:

reset schematic http://www.m0g.net/stuff/arduino-uno-schematic-reset.png

So basically, when the firmware of the Atmega8u2 (on the left) is pulling the pin 13 low, a reset is triggered for the Atmega328 on the right.

Another design was achieving the same thing using the DTR and RTS lines of the FTDI component (left) to trigger a reset on the Atmega328 (left).

To avoid this behavior, a 10μF capacitor between Reset and Ground is enough, but you can also cut the RESET-EN trace to prevent the auto reset.

That thing does not happen with the Arduino leonardo and Micro, with the firmware Caterina does act on the DTR line, but on whether you open a connection at 1200bps. That's because both arduinos have an AVR microcontroller that can directly "talk" on USB. There's actually a topic about how to trigger a reset.