Questions tagged [uart]

A UART is a Universal Asynchronous Receiver/Transmitter. This refers to the "hardware" serial port in the processor. Use this tag for questions about hardware serial.

Filter by
Sorted by
Tagged with
11
votes
2answers
15k views

What's the difference between all the Software Serial Libraries? Which one is Arduino Nano compatible?

There are so many Software Serial Libraries, what are the differences between them? And which one I can use with my Arduino Nano? For my Arduino Nano I need one Hardware Serial Port and one Software ...
0
votes
1answer
3k views

Sending data using Bluetooth SPP-C Module without a Breakout-Board

tl;dr I can't send data using the raw SPP-C Bluetooth module without a breakout board. The communication via UART works fine as I am able to issue AT commands and get proper responses. But when ...
2
votes
1answer
8k views

Simple Multiple RX/TX SoftwareSerial?

In this project I will be using multiple ESP8266 WiFi modules (4) connected by software serial to an Arduino Leonardo Micro (1 UART). I plan to rotate between all 4 (starting with 2): Open port, write,...
1
vote
1answer
2k views

Casting a struct member between uint8_t and char, with regard to serial transfer

Im simply trying to pass my payload to another device that has the same architecture and struct. I'm using UART to transfer, and modeling the protocol from EasyTransfer. When I call Serial.print((...
1
vote
1answer
1k views

ESP8266 not able to communicate over serial connection with arduino UNO

This is the code I uploaded in Arduino UNO: #include<SoftwareSerial.h> SoftwareSerial ESP(2,3); // RX, TX //ESP RX-->3(UNO) TX-->2(UNO) void setup() { // Open serial communications and ...
0
votes
0answers
1k views

Arduino Due and BNO055

For a physical activity monitoring project, I am developing a prototype based on an Arduino Due and several IMUs (BNO055 from Bosch). I have to collect the data from the sensors simultaneously (3 for ...
0
votes
1answer
66 views

I want my arduino mega to read from all 4 serial ports at the same time, running sequentially through each one

I currently have the code running through Serial1, which works exactly as I want it to: int RFIDResetPin = 13; void setup() { Serial.begin(9600); Serial1.begin(9600); Serial2.begin(9600); ...
0
votes
2answers
19k views

How do I know the IP address assigned to an ESP8266?

I have programmed an ESP8266 using the circuit and program below. I tried to open the SerialMonitor once the program is uploaded to the ESP8266. I am getting an error when I am trying to open the ...