Questions tagged [sleep]

Sleep refers to a form of power management, where the processor can be instructed to enter various levels of "sleep". Use this tag for discussions about sleep mode.

Filter by
Sorted by
Tagged with
13
votes
2answers
12k views

Put ATmega328 in very deep sleep and listen to serial?

I have investigated the sleeps options of the ATmega328, and read a few articles about it, and I would like to understand if there are more options. So I would like to get as low current as possible, ...
3
votes
2answers
7k views

IR Receiver interrupt and arduino sleep mode

I need to put my arduino into the sleep mode in order to consume less power. My arduino receives IR data and do some work with it, but I need to make it sleep until there is no data. If the data has ...
5
votes
2answers
2k views

How to deep sleep ATtiny/ATmega (to run for years with batteries) but still detect a button press?

Question (TL;DR): what is the optimal method to deep sleep (to run an ATtiny45 or ATmega on batteries for 1+ year) but still be able to detect a button press? Is it possible to deep sleep until a ...
6
votes
1answer
565 views

Choosing right Sleep state

I'm planning on building an LED clock, but I want it to be lit only when I press the POWER button on my remote control. Using an IR receiver, which Arduino sleep mode should I use to reduce the ...
1
vote
1answer
4k views

ESP8266 deep sleep and MQTT

I am working on a project were I am putting my board into deep sleep mode, and it wakes up with an interrupt from a sensor. When it wakes from deep sleep I would like to send a message to my MQTT ...
5
votes
1answer
120 views

Converting a standard setup/loop sketch to a low power application?

Suppose I have a typical setup/loop style sketch, such as this one which turns on an LED when a button is pressed. How do I modify this so that it enters low power mode, awakes on the button press, ...
5
votes
4answers
3k views

How to keep accurate millis() while using ADC_sleep mode?

millis() uses timer0 (linked to CPU clock) to count time, but ADC_sleep mode stops the CPU clock, therefore millis() will drift (lag behind) after each ADC conversion performed in ADC_sleep mode. ...
1
vote
1answer
65 views

Input Capture with Sleep Enabled on ATM32u4 board only works every second reading in SLEEP mode

In short: I have an Input Capture code and a Power-Saving code combined into one program. Both are adapted from Nick Gammon's examples that work fine independently. When I combined them into one ...
1
vote
1answer
665 views

Waking up async the Arduino while it's sleeping periodically [duplicate]

I´m using LowPower.h and PinChangeInt.h libraries to put my Arduino into the sleep mode every 8 seconds and then it wakes up, modifies a counter and it goes to sleep again, but also I need to wake it ...
0
votes
1answer
215 views

Deep Sleep Reset with Shock Sensor

I am trying to design a circuit that wakes my ESP8266 (Wemos D1 Mini) from deep sleep using a shock sensor. I can achieve this using the reset pin but I need it to ignore further requests to reset to ...
0
votes
1answer
575 views

Use lowpower-libary and still use serial connection and other things

I managed to get the LowPower libary working on my Arduino Micro. This code works perfectly: #include <LowPower.h> void setup() { // initialize digital pin LED_BUILTIN as an output. ...
0
votes
2answers
4k views

Wake up ESP8266 from deepSleep with a button

I have a button with two isolated tracks. I want to be able to wake up esp from deepSleep with this button, and also detect that it was clicked. So i can't connect it to reset, because esp won't work ...