Questions tagged [resistor]

Passive electronic component which reduces current flow in a circuit, dissipating power as heat.

8 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
2
votes
0answers
430 views

How to use Honeywell NBP Series Sensor with Arduino

I am trying to use a HONEYWELL NBPDANN100PAUNV Pressure Sensor. I found an example here http://www.circuitstoday.com/interfacing-pressure-sensor-arduino As this example says as instrumentation ...
1
vote
0answers
19 views

Arduino Uno Force-Sensitive Resistor

Would any one know how many Force-Sensitive Resistors that a Arduino Uno can handle being hooked up to at one time?
0
votes
0answers
38 views

Button example: resistor vs wire

I am playing with this basic example: Arduino: Button There're a lot of existing questions about why to connect button to the ground. I get the idea more or less. Is done to avoid "noise" during ...
0
votes
2answers
247 views

multiple RC522 RFID on arduino yun

I was trying for one month to make multiple RC522 rfid readers work together on SPI on an arduino yun, one works fine, but if I plug 4, each with a specific slave select, only one, sometimes 2, ...
0
votes
0answers
43 views

Control 12V power with 3 transitors to 3 seperate consumers

I have this shematic. With one electrical Pump and two solenoid valves I want to control via the arduino. Here are the specs for the parts: Pump: 12V max. 250mA Valve 1: 12V max. 160mA Valve 2: ...
-1
votes
2answers
50 views

Load Resistor Use for Voltage Sensing by Arduino

I connected a piezoelectric film to a Arduino Uno board via analog input. However, as I was getting very high voltage values (reaching 5 volts without much movement). Therefore, I added a 1 megaohm ...
-1
votes
1answer
1k views

Pulse counter to measure flow-rate: 0 Pulse issues

I am using a Netafim M-Series flow meter interfaced with a UC-32 Arduino. The goal of this is to create a pulse counter than in turn will allow us to determine flow rate in the meter. (1 US gallon per ...
-1
votes
1answer
507 views

Minimum value of a pull-down resistor

I've just started working with the Arduino UNO SMD edition and I'm also quiet new to electronics in general. Recently I wanted to try out this tutorial https://www.arduino.cc/en/Tutorial/Button and I ...