Questions tagged [peltier]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
2
votes
2answers
54 views

4 Pelteir Plate Water Bottle wired to Arduino Uno

Note - I plan to use the Arduino Starter kit to make this project. Hey everyone, I've had an idea for a project recently and I would like to get some insight on its plausibility. Is it possible to ...
0
votes
1answer
32 views

Part of Board exploded when Peltier Plate was wired t(o Board

Photos and Screenshots: https://imgur.com/gallery/bpmJglE By the way, I used a screenshot that was originally from this post: Have I bricked my Arduino Uno? Problems with uploading to board Hey guys, ...
0
votes
1answer
92 views

How to control one Mosfet with another mosfet

I've got 4x 12V 6a peltiers and some 3d printer mosfet controllers to drive them using PWM with my arduino. But I've found the mosfets need ~7V to switch on, so I'm now wanting to control them with ...
0
votes
2answers
261 views

Powering Peltier using solar panels

I am a beginner to electronics and trying to make a portable air conditioner using a Peltier cooling pad (12V). I am planning on using a solar panel to power the Peltier and looking forward to your ...
0
votes
1answer
384 views

Connecting Peltier module to Arduino Nano

I am a beginner to Arduino programming and started working on my first Arduino project recently to power a Peltier cooling pad. Below is the code I used and in the circuit, I connected the positive (...
-2
votes
2answers
651 views

Connecting Arduino to a Peltier Module [duplicate]

I am trying to make a cooler using Peltier Modules, the Peltier Modules and the fans switch on when the Temperature sensor attached to the circuit reads above a certain threshold. But I know that ...
1
vote
1answer
2k views

Motor driver not able to drive motor in reverse direction [closed]

In my recent project, I'm using DC motor driver 24V 20A[RKI-1340]. Motor Driver After reading the manual of this I figure out information for this motor driver. Basically, this motor driver has 5 ...
0
votes
0answers
2k views

Peltier not driven - Arduino-PID-AutoTune-Library

In my recent project, I'm working with Peltier module. And I tried out to adjust manually to set the value of Kp, Ki, and Kd. But it not so convenient to control the desired temperature. So for the ...
1
vote
1answer
3k views

How to set PID parameter Kp, Ki and Kd?

Right now, I'm working with Peltier module using PID algorithm. I search out on the Internet about this and so I found that there are three parameters Kp, Ki and Kd. And everyone uses the different ...