Questions tagged [esp]

The tag has no usage guidance.

Filter by
Sorted by
Tagged with
-1
votes
1answer
29 views

How to prevent flickering relay upon waking from deep sleep using ESP01 board?

I have a cheap ESP01 relay module and am using it with ESPEasy. I soldered the GPIO pin 16 to RST to allow deep sleep and that all works great. However when the unit wakes up the relay flickers quite ...
0
votes
1answer
22 views

I2C comunication, ESP->Nano on endTransmission no ACK fron nano

i am trying to communicate between ESP(master) and arduino nano(slave). This is only a prototype and all works fine. But i want to add multiple arduinos and therefor i need to detect if the arduino ...
0
votes
0answers
56 views

I'm getting an error while uploading my code to esp8266 via an arduino (FatalError('Failed to connect to %s: %s' % (self.CHIP_NAME, last_error)))

Arduino: 1.8.13 (Windows 10), Board: "Generic ESP8266 Module, 80 MHz, Flash, Legacy (new can return nullptr), All SSL ciphers (most compatible), dtr (aka nodemcu), 26 MHz, 40MHz, DOUT (compatible)...
0
votes
1answer
53 views

Problems with detecting button digital state

I am trying to start an event after pressing and holding the FLASH built-in Nodemcu button for a specific time, I wrote two functions, one for debouncing and detecting the state, the other is to ...
0
votes
1answer
35 views

Unable to send UDP packets while performing OTA update on the esp8266

I am sending specific UDP packets with my esp8266 every 5s, I have added an OTA update command, and added the update_progress callback aiming to send it back to my laptop, using a serial terminal I ...
0
votes
1answer
35 views

ESP01 and Arduino - Serial port confusion

I'm trying to understand how to think about ESP01 devices and arduino connectivity I purchased one of the USB programmers from Ebay to program the ESP01 - this works nicely, I can see the ESP doing ...
0
votes
0answers
28 views

How to use maximum GPIO on ESP12e [duplicate]

I'm using esp12e for my project and encountered difficulty in using more than 5 GPIOs. I have connected GPIO15 to Ground, GPIO0 to VCC, Enable to VCC (Connections as as per attached image). I'm able ...
0
votes
0answers
52 views

ESP8266-01 & Arduino Uno Problem

I am having a problem when I want to run code like this on a Arduino Uno with esp8266-01. It's not working. In serial monitor nothing about esp. #include <SoftwareSerial.h> SoftwareSerial ...