Questions tagged [enc28j60]
Microchip's ENC28J60 10BASE-T stand alone Ethernet Controller with on board MAC & PHY, 8 Kbytes of Buffer RAM and an SPI serial interface.
5
questions
3
votes
1
answer
167
views
The gateway is not working in Arduino EthernetENC
I am using ENC28J60 and EthernetENC library to connect an Arduino UNO with ATmega328 to the network. Everything works fine within the local network, but outside of it, I cannot ping the device. What ...
1
vote
1
answer
474
views
UDPSendReceiveString example using Arduino Due with ENC28J60 Ethernet Module
I was trying to learn how to use UDP protocol to use in my automation project to send commands to an Arduino Due on ethernet with an ENC28J60 breakout board which I have connected to the Due from SPI ...
- 111
1
vote
0
answers
461
views
ARDUİNO MODBUS TCP CONNECTİON
I am trying to communicate with PC by using modbus TCP communicate. When I use this code I can't communicate. Dou you know guys what is the problem? My ethernet Module is working I know that because I ...
- 29
0
votes
1
answer
181
views
EtherCard library without TCP
I have connected some sensors to an Arduino Uno (but the final code should run on a Pro-Mini) with an ENC28J60 shield. The sensor code works fine - until I add EtherCard. I tried UIPEthernet first, ...
- 256
0
votes
1
answer
309
views
How should I customize UIPEthernet constants?
I am using UIPEthernet to get an Arduino Nano to drive an ENC28J60 Ethernet Shield for a UDP-based application. I'm customizing a number of its #define parameters to change default settings to save ...
- 173