Questions tagged [buzzer]

An electrical device, similar to a bell, that makes a buzzing noise and is used for signaling.

7 questions with no upvoted or accepted answers
Filter by
Sorted by
Tagged with
0
votes
1answer
43 views

Is there a way for keypad to stop the buzzer while it is running?

I am new to arduino, currently I am looking for a way to make the keypad able to stop the buzzer making a siren alarm when password are keyed in wrong and able to move into password screen by pressing ...
0
votes
0answers
60 views

is there any archives of melody tones for buzzer used in arduino?

I am using buzzer in my arduino and I read some articles about using array of tones(notes in music) with different frequencies to play play pleasant melodies.however, I do not find any site and ...
0
votes
0answers
35 views

How to stop the screeching noise that comes from buzzer?

I use sfm-27 dc 3-24v Buzzer. It sounds fine if i close the buzzer using my palm but if i doesn't close it, it will make a screeching noise. I play melody using the buzzer so the sound is important. ...
0
votes
0answers
25 views

Shall an active piezo buzzer module draw as much as 10mA on its signal pin?

I have connected an active piezo buzzer to my arduino: KY-012 Active buzzer module. I was a bit surprised that it drew like ~10mA on the signal pin from my nodemcu, which I find a bit weird, since ...
0
votes
0answers
24 views

How to stop and repeat a melody using a button?

How can we make our melody stop when we press the button the first time and repeat the melody when we press the button the second time? // Noterna defineras #define NOTE_B0 31 #define NOTE_C1 33 #...
0
votes
0answers
224 views

Multiple Servo motors with an ultrasonic sensor

I am building a robot arm with 6 servo motors that works with an ultrasonic sensor. The purpose of the program is when an object is detected at 20 cm (fixed position) from the sensor, the buzzer and ...
-1
votes
1answer
126 views

How to use TimerOne while calculating time?

I'm trying to get warning with buzzer while I get same values on 3 seconds. But first warning doesn't wait 3 seconds. Second warning is correct. Code is attached. BlinkLED1() method is same BlinkLED2. ...