Stack Exchange Network

Stack Exchange network consists of 175 Q&A communities including Stack Overflow, the largest, most trusted online community for developers to learn, share their knowledge, and build their careers.

Visit Stack Exchange

All Questions

Tagged with
0
votes
3answers
398 views

How can I get my (Arduino) Pro Micro schematic to allow me to program it through GPIO instead of USB

I'm trying this project so far I've got the schematic of a Pro Micro, which is powered through GPIO from a Raspberry Pi Zero, and want to remove the micro usb connection and able to flash it using an ...
0
votes
1answer
382 views

Use ESP8266 GPIOs after Flash Startup

I'm a bit confused about the ESP8266 launching and GPIO behaviour. When I'm programming the ESP8266 I have to set GPIO2 high and GPIO0 low. But when I want to use the ESP8266 in my project I have to ...
1
vote
1answer
3k views

NodeMCU does not boot up when GPIO pin is high

I have a NodeMCU board connected to a door and there is a micro switch that makes one GPIO pin (GPIO15 - D8 in this specific case) go high when the door opens. My problem is if I lose power while the ...
6
votes
1answer
2k views

Pin 13 fires relay when powering on… How to disable?

Pin 13 fires relay when powering on... How to disable? I'm using pro mini 5v 16MHz and a DC 12V 2 Channel Relay Module Optocoupler. The relay Jd-VCC is powered by a 12V and it's VCC is 5V (the same as ...