Questions tagged [arduino-motor-shield]

An extension board for Arduino which provides functionality for controlling DC/stepper motors and other inductive loads (such as relays and solenoids).

Filter by
Sorted by
Tagged with
2
votes
3answers
765 views

Motor shield leaves no pins accessible

I just bought a motor shield for my UNO, in the pic below: Plugging it into the uno leaves no pins accessible on the board. I’d like to use it to build a robot car, but there’s nowhere to plug in the ...
2
votes
2answers
1k views

Motor shield and wireless transceiver compete for same pins

I would like to use these 2 components with an Arduino Uno: Arduino Motor Shield R3 nRF24L01 2.4GHz Wireless Transceiver I use Stepper for the motor shield, and SPI + RF24 for the wireless ...
0
votes
1answer
49 views

can't power up arduino from dc jack

Yesterday I was working on Arduino based bluetooth car. I was using adafruit motor shield v1. Arduino and shield were on same power supply(11v li-ion cell battery). Every thing was fine. I decided to ...
4
votes
2answers
1k views

How can I connect the Tamiya double gearbox to Arduino Uno?

I'm working on building my first robot. this is my first foray into DIY electronics. I already have an Arduino Uno, and I have ordered the Tamiya double gearbox here. My goal is to control the gearbox ...
3
votes
3answers
9k views

Why is my Adafruit motor shield not spinning my motors?

I'm using the Adafruit Motor Shield v2.3. I'm powering the Arduino with a USB cable and I'm powering the motor shield with a 9 volt battery. I removed the vin pin, and I'm using this tutorial/code to ...
2
votes
2answers
152 views

Problem with wrapping Adafruit Motor Controller function calls in a class

I'm working on an Arduino robot and I ran into a problem when reorganizing my code. I have an Adafruit Motor Shield v2.3 connected to an Arduino Uno. My robot can be controlled using a bluetooth ...
2
votes
1answer
454 views

Motor running during Motor Shield R3 reset

I have a problem with the Arduino Motor Shield R3 on an Arduino Uno. I Have a DC Motor on the A Channel and the Shield is connected to an external power source. When I reset the Arduino card the motor ...
1
vote
1answer
1k views

Arduino Motor Shield and Adafruit CC3000 WiFi Shield Compatibility

My question is similar to this one: Motor shield and wireless transceiver compete for same pins But not exactly the same! I would like to know if the solution is as practical, though. I have an ...
0
votes
2answers
558 views

Pro Mini 5v with Adafruit motor shield v1 power sharing problems

I am trying to convert a RC car into autonomous car using Arduino Pro Mini 5v 16 Mhz. I have done this with UNO and Adafruit motor shield 1.0 with 4 gear motors and one micro servo for mounting range ...
0
votes
1answer
278 views

Ultrasonic sensors with 12v motors will not work! (ADRUINO)

ok... so I am using four 12V motors and one ultrasonic sensor with a motor shield... and I am getting some odd results... in my code I have it so when the distance to a object is less than 4 cm it ...
0
votes
1answer
1k views

Which battery should I use to power arduino+motor shield + two 200 RPM (3.6V/1.5A)motors

I am using two motors ( from old two drill machines - same kind, these are 3.6v motors ), connected to arduino + arduino motor shield seeed studio v2. When I measured the both motors (indvidually) ...