Questions tagged [adapter]

A device for connecting pieces of equipment that cannot be connected directly.

Filter by
Sorted by
Tagged with
2 votes
0 answers
71 views

Do these types of wires exist? [closed]

I was wondering if the following type of wire adapter existed. Because I have some small JST pins and I need to connect them to some JST XH pins. (Preferably on amazon): JST to JST XH adapter
DigitalRookie4's user avatar
1 vote
1 answer
81 views

Separate control unit from LEDs

I am using an adapter (12 VDC, 2A) and I want to be able to power an LED strip with it plus the control circuit. The problem is that the Atmega328 reboots, but when I only power up the LED strip with ...
JOSEPH's user avatar
  • 21
0 votes
0 answers
265 views

Power up Arduino using AC/DC Adapter

Wanna get your advice regarding powering up Arduino Uno using AC/DC Adapter to the barrel jack. The first adapter I use couldn't work and the shop which I bought it from said the adapter was short ...
Zac's user avatar
  • 11
0 votes
1 answer
1k views

HC-05 with ELM327 mini OBD2 Bluetooth adapter connection problem

I am using Arduino Uno and HC05 Zs-040 Bluetooth module to establish a connection with ELM327 mini OBDII Bluetooth adaptor. I have tried more than 15 different sequences of AT commands and most of ...
MuhammadKhaled's user avatar
3 votes
2 answers
10k views

Connecting an Arduino to a servo with an external power supply

I have purchased an MG995 servo (4.8-7.2V operating voltage, 170MA no load operating current draw) and will power this using a 5V, 2A mains plug pack. Do I need a breadboard to connect this with my ...
Stacey1234's user avatar
2 votes
3 answers
9k views

ESP-01 adapter and logic level converter

I read that I'll need a logic level converter like this to run an ESP8266-01 from the Uno. But I saw this ESP adapter: http://www.ebay.com/itm/ESP-01-ESP8266-Serial-Wi-Fi-Wireless-Adapter-Module-3-...
shinzou's user avatar
  • 155
-1 votes
1 answer
117 views

Powering leds from arduino with adapter

Sorry for having (again) a beginners question, but I was wondering something. If I would want to drive like 20-30 LEDs from an Arduino (Uno), and I want to use an external adapter (12V, 1A), going ...
Michel Keijzers's user avatar