I have really been suffering with my simulation! Tried connecting my arduino mega 2560 to COMPIM (used as GSM Module) in my circuit and also loaded sample code but damn! In vain! I wanted to view the data sent in virtual terminal but am getting nothing! and its also complaining of excessive CPU usage.
This is the circuit as seen below in Proteus.
And thereafter, the log messages are displayed as shown below.
Someone please help me out. Am I making a mistake oh? Infact the arduino code for displaying in the simulation is also giving me hard time. The one am using is as shown below.
#include <SoftwareSerial.h>
SoftwareSerial mySerial(10, 11); // RX, TX
void setup()
{
// Open serial communications and wait for port to open:
Serial.begin(9600);
while (!Serial) {
; // wait for serial port to connect. Needed for Leonardo only
}
Serial.println("Goodnight moon!");
// set the data rate for the SoftwareSerial port
mySerial.begin(9600);
mySerial.println("Hello, world?");
}
void loop() // run over and over
{
if (mySerial.available())
mySerial.println("Hello, world?");
if (Serial.available())
mySerial.println("Hello, world?");
}
Will b every grateful for any help offered.