Can someone explain, step by step, along with all software I must use for using Windows command prompt to build an Arduino sketch (.ino file )?
I've followed these steps but I can't.
Arduino Stack Exchange is a question and answer site for developers of open-source hardware and software that is compatible with Arduino. It only takes a minute to sign up.Sign up to join this community
The command line interface of the Arduino IDE is described in this document
For example, this command will compile and upload the Blink example to my Arduino Leonardo
./arduino --upload --board arduino:avr:leonardo --port /dev/ttyACM0 --verbose examples/01.Basics/Blink/Blink.ino
Foot note: with IDE 1.6.0, there is an experimental version of the IDE for recent MacOSXs. It doesn't yet support the command line. If you need the command line on Mac, use the recommended version. This will be fixed with 1.6.1