4

Like subject all ready telling you, I blew up my 3th Nano every.

I mounted them on a perf board, soldered with 99% tin 1.0mm and a Flux, cleaned with flux remover, etc... When I then power them up through USB I have a short on pin 29 and 30 (Vin Gnd). And the board is ready to go directly in the poubelle (the garbage thing).

Second and third time, after soldering I scratched the space between both pins to make sure there is no connection. But... Yip again. Is this a common issue? Am I overseeing something?

Did my measurements with multimeter. No shorts.

pins

board

layout

pinout

16
  • 1
    which perfboard did you use? ... what is the picture supposed to show? ... you have provided zero information about what you did
    – jsotola
    Aug 30 at 16:46
  • 1
    have you tested all relevant pins for connections? I mean actually testing them (for example with a multimeter)
    – chrisl
    Aug 30 at 16:54
  • 1
    I took the time to hang the nano on my bench power to show you what is happening. What you're seeing here are pins 29 and 30 Vin and ground. drive.google.com/file/d/183kBK4hXRMbkuoGcrJJOLEInRQ5zVFIP/…
    – Joeri VA
    Aug 30 at 19:10
  • 1
    Use pin headers and check for the shorts before you'll insert board...
    – KIIV
    Aug 30 at 19:26
  • 2
    I don't know "welco". Is it an electronics solder or a plumber's solder? The same for the flux: is it electronic flux or plumber's flux?
    – Majenko
    Aug 31 at 12:34
2

If i am not wrong you have soldered nano directly to the perf board, which i don't recommend at all. You could try soldering a female strip pin on to the pref board and insert the nano board in the strip pin. This way you could easily remove/install the board easily as you wish. enter image description here

1
  • Since whoever down-voted this didn't bother to say, I'll offer a guess as to the reason. They appear to still be developing the question. And one of the comments suggests doing this exact thing, though, I think as a diagnostic measure rather than answer.
    – timemage
    Sep 4 at 13:20

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.