1

Good evening guys,

Looking for any help on interfacing the above GSM/GPRS module with arduino.

Connections:

VCC and GND of module- separate power supply, 5v 3A

URX to pin 2 UTX to pin 3

Common GND between arduino and separate supply.

Tried AT command code for A6 module, getting +CREG:3 on serial monitor.

Same connections as above with GSM send messages code example on arduino-

Doesn't go past "Sms messages sender

4
  • what is your question?
    – jsotola
    Aug 17, 2021 at 22:29
  • Is there a way to interface the ga6 module with arduino. I saw some posts say you must flash the module to A6
    – Dean N
    Aug 18, 2021 at 5:00
  • Also is there a GA6 module code I could use
    – Dean N
    Aug 18, 2021 at 5:01
  • Would this help: create.arduino.cc/projecthub/EasyMades/…
    – PimV
    Oct 4, 2021 at 17:23

0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Browse other questions tagged or ask your own question.