I recently purchased a W5100 based ethernet shield for my arduino Uno, and looks like this. I had been following the guide here, and connected the pins accordingly - 5V to 5V, GND to GND, MOSI to 11, MOSO to 12, SCK to 13, and SS to ten.
I booted up a default sketch (webServer, under Ethernet), and plugged in and ethernet cable. - PWR, LINK, SPD,and FDX all lit up, with Rx blinking for first 10 or so seconds. I then go to the IP specified on the arduino sketch, and nada. Also, my router doesn't show the shield under the attached devices.
Therefore, I figure it's a problem with my connections. Can anyone help me? Googling has only brought my lots of info about shields, and little info on these modules.