1

Just-purchased UNO/R3/WiFi. Lees Electronics / Vancouver, BC, Canada. https://leeselectronic.com/en/

In "tools' Board set as UNO WiFi. In "tools" Port COM5 not ID'd as Arduino. Run Bootloader. Initially, when using COM7 (IDd as "Arduino UNO'). Upload fail. Using COM5, Attempt to upload results in 10 attempts: First 2 (of 10) errors message sets below:

Using Port                    : COM5
         Using Programmer              : arduino
         Overriding Baud Rate          : 115200
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x27
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x27

Tom Kane / Feb 10, 2021

1
  • Your board has a row of switches on it, if I've located the correct one. What position are all those switches in? – timemage Feb 10 at 17:57

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.