1

Title says the majority of it. I'm looking to make a trim wheel for flight sim using a rotary encoder, the Joystick library and an Arduino Leonardo. I wasn't sure if it would be better to make it a button press or have it be an axis, possibly the Rx, Ry, or Rz axis.

Thanks in advance!

5
  • 2
    are you not the one that knows what you want?
    – jsotola
    Jan 24 at 9:07
  • As you build that project, it is up to you to decide, wether you want to control trim via a joystick or button presses.
    – chrisl
    Jan 24 at 11:12
  • @jsotola I had an idea of what I thought would be best, but I wasn't sure if anyone thought differently. Thanks though! Jan 24 at 22:25
  • @chrisl I had an idea of what I though would be best, but I wasn't sure if anyone thought differently. Thanks though! Jan 24 at 22:25
  • what I thought would be best ... yes, it is your job to define what best means ... nobody else can tell you what is good for you ... and nobody else's opinion is relevant unless you ask a technical question
    – jsotola
    Jan 24 at 22:48

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.