2

I have 2 types of Pro-Micro(as shown here), both 5v, micro-usb, which worked as expected, until, accidentally were flashed as 3.3v using the Arduino IDE.

At first I thought that the fact it stoped working right after, has nothing to do with that error, but since again, did the same mistake, I understand that this is no coincidence.

After doing so, boards seemed to be powered on ( leds are ON ), but are not found under port in the Arduino IDE.

Are they really can be destroyed by such an error ?

5

Holding RST and GND pins after re-connecting USB, showed it on port menu. needed another such holding, prior to upload.

All good now.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.