1

I receive this message: "device signature 0x000000" when a try to burn the bootloader on a atmega328p-au (SMD) inserted on PCB i am using arduino uno as isp i already uploaded the ArduinoISP sketch and i check "Arduino as ISP" as programmer with "arduino nano" as board

i do not know what is the problem i tried to check the ISP wiring with the arduino uno and everything is alright what i noticed is that when i remove the GND wire attached to ISP the pin13 of the arduino lights up when i connect it it lights off i do not know what to do here is the full schematic enter image description here

Thank you for helping me

Improve this question
18
  • Not necessary related, but what the D4 for? it make your 7805 ground 0.6v higher than the ground.
    – hcheung
    Nov 8, 2020 at 7:59
  • If all the lights go out on the Arduino when you plug it in, it sounds like a short circuit...
    – Majenko ♦
    Nov 8, 2020 at 10:47
  • 1
    On an unrelated note: where are all your decoupling capacitors?
    – Majenko ♦
    Nov 8, 2020 at 10:51
  • @Majenko Can you explain me please why the short circuit happens and how to fix it ?
    – JOSEPH
    Nov 9, 2020 at 17:09
  • 1
    Did you ever find the solution? I'm stuck as well.
    – Thom
    Jul 10, 2021 at 20:15

0

Reset to default

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge that you have read and understand our privacy policy and code of conduct.

Browse other questions tagged or ask your own question.