I am using ublox zed F9P multi GNSS module. I have to program it for its configuration messages. Like I have to run a specific configuration of my receiver with the help of Arduino. I know arduino parse the GNSS sentences but can anyone tell me how to write code for ublox configuration commands such that that command can change setting of the receiver upon burning it in Arduino. Also, that code should retain in the receiver even if arduino is disconnected (closing arduino IDE console). Please help

  • you write the code using the Arduino IDE – jsotola Sep 22 '20 at 6:58
  • yes code will be written in arduino IDE. – Aroo Sep 22 '20 at 7:11
  • You would send the commands over the same serial channel that you read the data from. – Majenko Sep 22 '20 at 12:32
  • can you give some example of sending these hex bites into Arduino? It will help me – Aroo Sep 23 '20 at 5:00

Here you find a standard library from arduino.


You can find the documentation here:


Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.