3

I have this project where I need a modbus tcp server that will host a series of sensor data for other modbus client devices to read. I use this Library by Andresoarmento

This is the code i am using from the library example:

#include <EtherCard.h>
#include <Modbus.h>
#include <ModbusIP_ENC28J60.h>

//Modbus Registers Offsets (0-9999)
const int SENSOR_IREG = 100;
//Used Pins
//const int sensorPin = A0;

//ModbusIP object
ModbusIP mb;

long ts;

void setup() {
    // The media access control (ethernet hardware) address for the shield
    byte mac[] = { 0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED };
    // The IP address for the shield
    byte ip[] = { 192, 168, 1, 120 };
    //Config Modbus IP
    mb.config(mac, ip);

    // Add SENSOR_IREG register - Use addIreg() for analog Inputs
    int i = 2200;
    mb.addIreg(SENSOR_IREG,i);

    ts = millis();
}

void loop() {
   //Call once inside loop() - all magic here
   mb.task();

   //Read each two seconds
   if (millis() > ts + 2000) {
       ts = millis();
       //Setting raw value (0-1024)
       int i = 0;
       i++;
       mb.Ireg(SENSOR_IREG, i);
   }

The enj28j60 module is working as i tested it. So, I used a modbus scanner(CAS SCANNER) which was unable to detect it. Can anyone tell me how to get this all working and test it?

Thank you in advance.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.