I am planning a build with my own enclosure for the arduino due. As an alternative i would like to bypass the power jack and usb port that are factory soldered onto the board, in order to use jacks mounted on the enclosure, along with a power switch.
I've looked at the info regarding the boards pin configuration at https://www.arduino.cc/en/pmwiki.php?n=Main/arduinoBoardDue, and would appreciate if someone could confirm or correct this:
Can i use an external 9V adapter through a jack connected to the Vin and GND pins, respectively?
According to This question, you can't connect an alternative programming USB port to Serial 0 TX/RX pins (Mega board). If this applies to the due as well, what do i need to break out the programming USB port?
Edit: Perhaps one of these puppies is the least complicated solution?