1

My problem is actually in two stages. I am very new to arduino uno and 8266-01. I have read many documents and watched videos for nearly 2 weeks, but I cannot even run the simplest "blink" example.

First of all, I installed the compatible software with an esp download tool as follows according to 6014h. And it seems okay. enter image description here

After triple check, my wires and connections where they have to . Rx->Rx Tx->Tx CH-3.3v GPI0 grounded Ground->Ground and also 8266-01 VCC connected to Arduino 5v with 3.3v regulator and connected with capacitor, to debug voltage i check with voltmeter.

Problem is: When I try to upload simple Blink example below imag. My IDE gives a very different output from the videos I watched. I could not understand the reason for this.

the IDE outputs on the all of videos that i watched, are while uploading

enter image description here

This kind of upload starts when it says upload and when it's finished, the program runs.

BUT!In my case my IDE is acts like that and nothing happens end of the upload.

enter image description here

My 8266 generic settings are as follows.

enter image description here

Led out pin in the blink example is 2 and GPI1 is connected to led to blink after all this explanation, where i missed up ?

Why i am taking different uploading process and code is not working?

7
  • Set flash mode to DOUT instead of QIO? You get different output because the videos you have seen are out of date and use an old uploading tool (esptool.exe) rather than the current one (esptool.py) or maybe the OTA tool (espota.py). – Majenko Sep 1 '20 at 8:51
  • I set the flah mode to DOUT. I uploaded sketch again and hard resetting via rst pin is occured again and not blinking or any other serial AT commands not working. I think i catch somethings but i dont know. Why my code is not running or how I run the code after uploaded ? – EKREM YİĞİT Sep 1 '20 at 9:06
  • you deleted the AT firmware with sketch upload – Juraj Sep 1 '20 at 9:16
  • 1
    buy a development board for Arduino sketches on esp8266. something like Wemos D1 mini. it has USB and controls the flashing mode and reset of the esp8266. with esp-01 you must manually handle io 0 and reset for every upload. I wire buttons to esp-01 for frequent flashing. Then for flashing I hold the button for io 0 and click the button for reset. then I release the io 0 button. – Juraj Sep 1 '20 at 9:24
  • 1
    My general advice these days: forget ESP8266 - use the ESP32. It's so much more capable. – Majenko Sep 1 '20 at 9:44

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.