0

I am using ESP32....the max Pwm signal of it is 3.3V...And I have to control two motors speed by TB6612FNG motor driver...when i was using Arduino.. The arduino can send max 5V Pwm signal to the motor drivers PWM pin.. And the motor runs at the exact speed...but now i have to use ESP32..which sends 3.3V and the motors slow down..

So what should I do to convert the ESP32's PWM signal to 5v and according If i change the PWM value at the program..the output will also change similarly as Arduino?? Please help me

Improve this question
0

1 Answer 1

Reset to default
1

Looking at TB6612FNG datasheet i read

Logic supply voltage (VCC) can be in the range of 2.7--5.5VDC

So, if you supply 3.3V to VCC all should be ok, if the motors themselves get enough power (via VM)

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Not the answer you're looking for? Browse other questions tagged or ask your own question.