0

So I'm having a little bit of difficulty here in my NEO-6M. The problem is it doesn't show any data in my serial monitor. My NEO-6M Led is already blinking so its already ok.

RX -> Pin3 , TX -> Pin4 , VCC -> 3.3v , GND -> GND

Serial Monitor: enter image description here

Code: https://github.com/mikalhart/TinyGPSPlus/blob/master/examples/FullExample/FullExample.ino

Improve this question
  • Have you crossed the serial lines? Arduino RX to GPS TX, Arduino TX to GPS RX – chrisl Feb 23 '20 at 9:03
  • I have but I already fix it, does it broke my neo? – TechHermit Feb 23 '20 at 9:57
  • What do you mean? The lines need to be crossed. And having them not crossed most likely doesn't break it – chrisl Feb 23 '20 at 10:18
  • Iv'e updated it now. @chrisl – TechHermit Feb 23 '20 at 16:15
1

I found a solution to my problem. On my first setup, I separate my GND of NEO-6M to Arduino and put connect it in breadboard that has powerboard on it because I thought it is only for electrical purposes but it doesn't since I encounter it.

Solution:

The GND of every module must still connect on the Arduino.

Improve this answer

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.