0

Good day everyone! what code should i used for sending sms message depends on the area. the things that i used in my protoype i have MPU6050 accelometer, SIM800C GSM MODULE, NEO6MV2 GPS MODULE. So the flow is if the Accelometer triggred the GSM module will get the GPS location only if the area is on the target location 1 so it will only send to the recepient 1. But if its triggred in another location, Targetlocation2 it will only send on receipient 2. My question is how to used the longitude and latitude data to get the exact data of what my gps module gets? so that i can use that data to send sms message on specific place or area thank a lot also i used TINYGPS.H LIBRARY thank you!

  • You get location information from GPS, and you have some target locations stored. You check, which of the targets is closest and send an SMS to the corresponding phone. And what exactly is your problem in detail? If you ask "How to do it?" rather show what you tried and why you are not satisfied with the result. And split the task into a couple of smaller ones :) – DataFiddler Feb 20 at 13:54
  • why are you asking again? ... arduino.stackexchange.com/questions/72626/… – jsotola Feb 20 at 16:06
  • Thank you DataFiddler i'm just asking for a format code use to set longitude and latitude, Is it float distance_between (float Lat1, float Lon1, float Lat2, float Lon2)? and how to set this for if statement? to send the sms if my location area is on the target Lat1 Lon1 thank you – Reiniel Cirujano Antonio Feb 20 at 22:36
  • sorry jsotola im just despirate sorry for my bad english – Reiniel Cirujano Antonio Feb 20 at 22:42

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.