1

I'm trying to burn bootloader to my clean crystals, atmega328p-pu.For this I use the 16MHZ crystal with two ceramic capacitors and USBASP programmer, on Windows 10 Pro. As program for burning I tried: Arduino IDE, AVRDUDESS,AVRDUDEPROG. But when I would to detect my chip(or in IDE try to burn the Chip)., I get this error: ` avrdude.exe: set SCK frequency to 1500000 Hz avrdude.exe: warning: cannot set sck period. please check for usbasp firmware update. avrdude.exe: error: program enable: target doesn't answer. 1 avrdude.exe: initialization failed, rc=-1 Double check connections and try again, or use -F to override this check.

avrdude.exe done. Thank you.

` From this error I understand that the target(My chips) Wouldn't to start. I checked my connection for 1000 times and I tested mt wires too, they works correctly. And supply 5V comes o chip and it become warm(it means that supply comes and it should start). I have got 5 chips And I tested all of them. I searched internet but nothing.

Please,help me, and say how can I burn them.

Best Regards, E.M.

9
  • My understanding of that error message is that your USBASP is unable to set the right clock speed. Maybe it's got inferior (out-dated) firmware on it...
    – Majenko
    Dec 1, 2019 at 22:21
  • Not only. In khazarma or in avrdudeprog it don't work too
    – E.M.
    Dec 2, 2019 at 9:40
  • It without the bootloader. And
    – E.M.
    Dec 2, 2019 at 10:07
  • Have you tried with another programmer? Like I said: the error looks to pertain to the programmer, not the software or the chip.
    – Majenko
    Dec 2, 2019 at 10:19
  • So can I use the Arduino As ISP? If yes should I change the SPI_CLOCK to (16000000/6) as I use the 16 MHZ crystal? And which baudrate should I use:19200,115200,1000000? in ArduinoISP sketch?
    – E.M.
    Dec 2, 2019 at 12:21

0

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Browse other questions tagged or ask your own question.