0

enter image description hereAny help is greatly appreciated! Trying to build a small door lock that is controlled by a finger print sensor, (I know it will not be very practical). My issue is with putting the hardware together, I have the sensor connected to the Arduno uno with the green and yellow to pins 2 and 3 respectively, then the red and black to the ground and 5V rail. My issue is not knowing how to go about connecting the adafruit chip to the breadboard as I am going to try to use wifi for this project. Secondly I noticed most people use the adafruit Fingerprint sensor which has the module and mine is just a cheap sensor from amazon and was wondering if it will still be able to work the same? Sorry for all the questions I am very new to this and I apologize for sounding so lost haha, anything helps. enter image description here

  • 1
    you have not told us what device you actually have ... saying that you connected yellow and green wires does not mean anything specific – jsotola Nov 24 '19 at 5:32
  • You should give us a link to that fingerprint sensor. Or even better: to it's datasheet – chrisl Nov 24 '19 at 13:35
  • sorry my bad, here is the link: amazon.ca/gp/product/B07TZQ6YTH/… – Jackson Nov 24 '19 at 20:13
  • There doesn't seem to be any information on the internet on how to use this device. Did it come with any manual or documentation ? – tavis Nov 24 '19 at 21:48
  • No that is my issue,I am kind of lost now, was hoping I wouldn't have to buy a whole new sensor – Jackson Nov 25 '19 at 2:08

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.