I have the following circuit

It has a simple dc motor that is OFF, and switches ON once a day for 2 seconds.

I use MOSFET IRF540N as a switch

I use L7805CV as a voltage regulator

I would like to have a review and to ask whether it is safe to connect this circuit to a 9v 1A (center+) DC wall plug.

I have measured the dc motor and it takes 60 mA when it is on with 5V.

enter image description here


The "Arduino" part of your schematic looks OK. 9 VDC to VIN on the Uno is OK. Connecting the MOSFET directly to the Arduino is OK.

Personally, I would connect a 1000 ohm resistor in series between the Arduino pin and the gate of the MOSFET. If you like to live dangerously like I do, and change wiring connections with power supplied to your Arduino, then a 1k resistor will limit the maximum current flow to around 5 mA. This is not going to "fry" anything if you inadvertently connect an output to power or ground.

The question about the L7805CV is off-topic, but a quick look at the datasheet suggests an input and output capacitor should be used.

I’m sorry to be the bearer of bad news, but the IRF540N is a poor choice as a MOSFET to use with a micro-controller. While it’s true that you are only drawing 60 mA, the VGS specified for this MOSFET is at 10 VDC, not the 5 VDC supplied by the Uno. A "logic level" MOSFET would be better suited for your application.

For more information regarding MOSFETs, please read: How to control a 12V solenoid valve with a mosfet?

| improve this answer | |

In general your circuit is fine, but the parts are pretty overpowered. If there is a reasonable voltage drop at the IRF540N you better choose a mosfet with a lower gate-source threshold voltage, if it works I'd say it's fine.

| improve this answer | |

You should not use a "naked" L7805CV. That voltage regulator requires a couple of capacitors in order to build a functioning voltage regulator out of it. You should be able to find instructions online for how to build one. Search on "L7805CV circuit" and you should find quite a few sample circuits.

That said, 9V is a good unregulated voltage to provide to the Vin line on the Arduino. Its built-in voltage regulator should be able to regulate that to 5V quite well, even with "bobble" caused by motor. (The built-in voltage regulator is able to handle input voltages from 7.5V to 12V, although if you feed it 12V and draw a lot of current out of the 5V line you may have overheating problems.)

You should also use a "logic level" MOSFET that can be driven with a 5V gate voltage.

| improve this answer | |

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.