0

I bought a DFrobot Beetle and it worked fine for probably an hour, then it just stopped working with Windows.

When I connect it to the computer I hear the "connect" sound, then within 5-7 seconds I hear the disconnect sound again.

I didn't do anything special with it. I connected a RDM6300 rfid reader and used an example code from a library. I think the last thing I did was to change a string output message in the console.

From then on it just disconnects.
I tried to email DFrobot but didn't get a reply.

What could have caused this?
What can I do to make it work again?
The reset pin didn't work.
There is not enough time to replace the code on the board before it disconnects.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Browse other questions tagged or ask your own question.