I salvaged segway motor with 8 wires. I did completed basic connection of 5 hall sensors and power from 36V lipo battery in the image below. When I connect self-learning wires then motor starts rotating so connecting must be right. So now how do I control the motor with arduino?

Controller is kkmoon motor regulator 350W - link

didn't find datasheet about motor but here are some Information:- Type: BLDC Motor Voltage: 36V no of wires:- 8 (3 wires for 3 phase, 5 for hall sensor) Power:- 300W


motor controller information

  • please provide a link to the motor datasheet
    – jsotola
    Oct 3, 2019 at 8:19
  • 1
    didn't find datasheet but posted some basic information above. Oct 3, 2019 at 8:28


Your Answer

By clicking “Post Your Answer”, you agree to our terms of service and acknowledge you have read our privacy policy.

Browse other questions tagged or ask your own question.