I just got my arduino and servo. But my servo may be acting strangely.
Whenever I tell the servo to go somewhere it keeps going to 0 than to that position and stops after 10-15 seconds or more.
This is the code used in this video
#include <Servo.h>
Servo myservo;
void setup()
{
myservo.attach(11);
myservo.write(50);
}
void loop()
{
}
https://www.youtube.com/watch?v=rsikknT7z6g
It is connected like this:
Ground from Arduino to breadboard row 3
Ground from external power supply to breadboard row 3
Ground from SERVO to breadboard row 3
Power supply positive to servo VCC
Servo signal to pin 11