Arduino RS485 shield to RS485 temperature & humidity sensor

Question

I’m try to get data from rs485 is not work please advise to me.

1.  Try to connect PC usb485 to DY-MD02 is work.
    Send command “AUTO” or “READ”

2.  Try to Arduino rs485 shield to DY-MD02 is not work.
    Send command “AUTO”

my code

''''

char command[4] = {'A', 'U', 'T', 'O'};

int n = sizeof(command)/sizeof(command[0]);   // Number of elements in an array

String incoming = "";   // for incoming serial string data

void setup()

{

      // initialize serial ports
      Serial.begin(9600);
      pinMode(EN,OUTPUT);
      digitalWrite(EN,HIGH); //Enable high, RS485 shield waiting to transmit data
      Serial.write(command,n); //Test send command Auto,Read to RS485
      delay(500);
}

void loop()

{

      String temp;
      digitalWrite(EN,LOW); //Enable low, RS485 shield waiting to receive data

      while(Serial.available() > 0 )
      {
          temp=Serial.read();
          Serial.println(temp);
          delay(1000); //Delay for some time, waiting for data transmitted
      }

}

''''

---

if change code to = Serial.readString() not show anything.

please help me Thank

---

to Juraj

Maker tell me can connect with Arduino uno and send manual to me.

see in attach file.

Answer 1

i'm tray change this code to readStringUntil, is OK

if(Serial.available() > 0)
  {
    temp = Serial.readStringUntil('\n');
    Serial.println(temp);
    delay(1000); //Delay for some time, waiting for data transmitted
  } 

Thank all for help me ^^

Answer 2

I will suggest try to use Modbus Master library it will help you get the data from sensor. The issue with the code is you are only sending the command but while interfacing with modbus there is a packet/ frame which you need to form and then send it the packet/frame format is in the below diagram

I will prefer use an Arduino Mega or other arduino which have more than 1 Serial port for communication. I also faced a similar issue but it was resolved after digging a little bit you can have a look at the issue here