0

In one of my earlier questions it was determined for me that my Futaba Servo should not be powered directly from the 5v pin of my Arduino and should instead be powered by an alternative source. I was told the Servo requires a “high current 5 volt power supply” so I’m wondering what my best options are as my knowledge in servo control is quite limited. Is there some type of board that helps with this? Do I need a specific battery? If the servo needs a battery could it run off of the same battery as the arduino? Im trying to keep my design as compact as possible so multiple battery packs could pose complications. The specific information can be found here. Thanks for any help!

0

Based on the link to the specifications, this is a "high speed, high torque" servo. Unfortunately, none of the information includes the maximum or typical current draw, though there are warnings to higher gauge wire than usual and to avoid long leads and Y-splitters.

These are indications that your power supply should be "beefy", and by the class of servos this is in, I would guess you need a supply capable of supplying 5V at up to 3 amps.

The "harder" the servo has to work to move, the more current it will draw. This servo wants around 5V, but 4.8V is acceptable from a 2S (2 series) LiPo battery pack.

4.8V, however, is not quite enough for a 5V Arduino at 16MHz (the standard speed). As long as all the Ground wires are connected together, you could have one battery pack for the Arduino and a 4.8V pack for the servo.

All that said, there are only 2 primary specification points of a power source -- Output Voltage and Max current. You should try to MATCH voltage ratings of a power source to the device being powered, and ensure the device being powered DOES NOT EXCEED the current rating of the power source.

Your Answer

By clicking “Post Your Answer”, you agree to our terms of service, privacy policy and cookie policy

Not the answer you're looking for? Browse other questions tagged or ask your own question.